Gardner-Denver RDT 30-150 Operating Instruction Manual BI010264 – PDF DOWNLOAD
FILE DETAILS:
Gardner-Denver RDT 30-150 Operating Instruction Manual BI010264 – PDF DOWNLOAD
Language : English
Pages : 599
Downloadable : Yes
File Type : PDF
DESCRIPTION:
Gardner-Denver RDT 30-150 Operating Instruction Manual BI010264 – PDF DOWNLOAD
INITIAL STARTING:
- Prior to start;ng the ROT-JO for the first time, become thorough ly familiar with all controls as
illustrated in figure 1. Shift all levers to be sure iTl are free and neutralize all controls
and the transmission shifter. - Note that the transmission shifter is an air valve and will not operate the transmission un less
the control air has reached approximately 100 psi. - Also familiarize yourself with the controls located in the truck cab.
LUBRICATE ALL GREASE FITTINGS:
Check all gear cases, chain case, and transmission, making sure
the oil is at the proper 1eve1. The hydraulic system is filled at the factory, however, check
reservoir and add oil to the proper level if necessary.
PREPARING TO DRILL:
After moving truck to drilling location, set parking brake, shift power take off into drill ing
position, and shift truck transmission to fifth gear.
LEVELING THE DRILL:
1. Pull master switch #31, on operators cab, to energize all panel switches and gauges.
2. Increase engine speed with throttle control #1.
3. Switch pulldown motor to “high” to speed up leveling jacks, with control switch #27.
4. Lower a11 three 1 eve1i ng jacks to the ground. This is accomplished by pulling up on
hydraulic control levers #6, 7, and 8.
5. Level the drill using the multiple plane level gauge #11 as a guide . Level the side to side
first then fore and aft. This procedure is recommended as the rear jacks operate indepen dent for
lateral leveling and the front jack is controlled with one control valve 17.
IMAGES PREVIEW OF THE MANUAL:
TABLE OF CONTENTS:
Gardner-Denver RDT 30-150 Operating Instruction Manual BI010264 – PDF DOWNLOAD
SECTION 1
SECTION 11
SECTI ON 111
SECTION IV
SECTION V
SC: CTIO;” VI
CONTENTS
CON TR0LS IDENTIFICATION
INITIAL STA~TING
PREPARII~G DRILL
LEVELING THE DRILL
RAISING f’.1AST
VERTICAL DRILLING
ANGLE DRILLIhlG
PREPARING TO DRILL
DRILLING
ADDING DRILL PIPE
RETRACTING DRILL PIPE
LOWERING MAST
BREAKOUT SYSTEM
START UP
THROTTLE ASSEMBL.Y
EMERGENCY SHUTDOWN
PULLDOWN SYSTE:v1
PULLDO’rlN HOIST
PULLDOWN MCTOR
PULLDOWN TRANSMISSION
HYDRAULIC SYSTEM
A. MAST RAISING
B. LEVELING JACK
C. BREAKOUT CYLINDER
PIPE RACK ASSEt1BLY
ROTARY CLUTCH ASSEMBLY
AIR COMPRESSOR ASSEMBLY
DRILLING AIR ASSEMBLY
PIPE DRAG ASSEMULY
BREAKOUT SLIP ASSEMBLY
MAINTENANCE & SERVICE
VIDEO PREVIEW OF THE MANUAL:
PLEASE NOTE:
- This is not a physical manual but a digital manual – meaning no physical copy will be couriered to you. The manual can be yours in the next 2 mins as once you make the payment, you will be directed to the download page IMMEDIATELY.
- This is the same manual used by the dealers inorder to diagnose your vehicle of its faults.
- Require some other service manual or have any queries: please WRITE to us at [email protected]
S.V