Doosan Electric Forklift Truck All Models Shop Manual

sample content from manual

AEB STARTER
– Introduction
The AEB- Starter is s tool to start the AEB and ISK of ergo power
transmissions.
It’s useful to work with the Transmission Display because
all messages about the AEB state is shown in the Display.
The AEB-Starter itself doesn’t show any in formations.
The AEB-Starter works with the diagnostic plug of
TCU which is in the engine hood.
To insure the highest level of shift quality,
AEB must be carried out under following conditions :
– After every replacement of the transmission,
TCU or the electro hydraulic control valve
ISK must be carried out under following conditions :
-After TCU or inching sensor is replaced.
-After each new adjustment of the inching linkage
AEB and ISK can be carried out independently each other.
AEB is started by pressing the button of AEB starter with the engine ignition switch turned at ‘Start’ position.
ISK is started by pressing the button of AEB starter with the engine ignition swich turned at ‘On’ position.
NOTE : The error code “F6” will be shown in the display as long as the AEB or ISK is not done.
After the replacement of TCU, the inching function is only active after successful completion of AEB and ISK
start.

Showing all 4 results

FORGOT PASSWORD ?
Lost your password? Please enter your username or email address. You will receive a link to create a new password via email.
We do not share your personal details with anyone.
0