CAT C-10 & C-12 Truck Engines Systems Operation Testing & Adjusting Manual – PDF DOWNLOAD
IMAGES PREVIEW OF THE MANUAL:
DESCRIPTION:
CAT C-10 & C-12 Truck Engines Systems Operation Testing & Adjusting Manual – PDF DOWNLOAD
MBJ1-Up (Engine)
MBL1-Up (Engine)
Important Safety Information:
Most accidents that involve product operation, maintenance and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills and tools to perform these functions properly. Improper operation, lubrication, maintenance or repair of this product can be dangerous and could result in injury or death.
- Do not operate or perform any lubrication, maintenance or repair on this product, until you have read and understood the operation, lubrication, maintenance and repair information. Safety precautions and warnings are provided in this manual and on the product.
- If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. The hazards are identified by the “Safety Alert Symbol” and followed by a “Signal Word” such as “DANGER”, “WARNING” or “CAUTION”. The Safety Alert “WARNING” label is shown below.
TABLE OF CONTENTS:
CAT C-10 & C-12 Truck Engines Systems Operation Testing & Adjusting Manual – PDF DOWNLOAD
Systems Operation Section
Engine Design 4
Engine Design 4
General Information 5
Glossary of Electronic Control Terms 6
Electronic Control System Components 10
Fuel System 12
Air Inlet and Exhaust System 26
Lubrication System 30
Cooling System 34
Basic Engine 37
Rear Power Take-Off (RPTO) 39
Compression Brake 39
Electrical System 42
Testing andAd justing Section
Fuel System
Fuel System – Inspect 46
Air in Fuel – Test 46
Electronic Unit Injector – Adjust 47
Electronic Unit Injector – Test 48
Finding Top Center Position for No 1 Piston 48
Fuel Quality – Test 50
Fuel System – Prime 51
Fuel System Pressure – Test 53
Gear Group (Front) – Time 58
Air Inlet andExhaust System
Air Inlet and Exhaust System – Inspect 59
Turbocharger – Inspect 61
Inlet Manifold Pressure – Test 64
Exhaust Temperature – Test 65
Aftercooler – Test 65
Engine Crankcase Pressure (Blowby) – Test 68
Compression – Test 69
Engine Valve Lash – Inspect/Adjust 69
Lubrication System
Engine Oil Pressure – Test 72
Engine Oil Pump – Inspect 74
Excessive Bearing Wear – Inspect 75
Excessive Engine Oil Consumption – Inspect 75
Increased Engine Oil Temperature – Inspect 75
Cooling System
Cooling System – Check (Overheating) 76
Cooling System – Inspect 78
Cooling System – Test 78
Water Temperature Regulator – Test 83
Water Pump – Test 83
Basic Engine
Piston Ring Groove – Inspect 84
Connecting Rod Bearings – Inspect 84
Main Bearings – Inspect 84
Cylinder Block – Inspect 84
Cylinder Liner Projection – Inspect 85
Flywheel – Inspect 86
Flywheel Housing – Inspect 87
Vibration Damper – Check 89
Compression Brake
Slave Piston Lash – Adjust 91
Control Valve (Compression Brake) – Test 92
Solenoid Valve (Compression Brake) – Test 93
Electrical System
Battery – Test 96
Belt Tension Chart 96
Charging System – Test 98
Electric Starting System – Test 99
Engine Oil Pressure Sensor – Test 99
Pinion Clearance – Adjust 99
Index Section
Index 101
VIDEO PREVIEW OF THE MANUAL:
PLEASE NOTE:
- This is the SAME exact manual used by your dealers to fix your vehicle.
- The same can be yours in the next 2-3 mins as you will be directed to the download page immediately after paying for the manual.
- Any queries / doubts regarding your purchase, please feel free to contact [email protected]
S.V